Door Window, Adjusting

Door Window, Adjusting

Special tools, testers and auxiliary items required

• Hex Ball Socket (T10058)

• Use to adjust the height

• Side Window Installation Tool (V.A.G 1739)

• Use to adjust laterally.

• Gauge (T10391)

Lateral Adjustment

• Adjustment dimensions, gap dimensions, refer to => [ Door Window Adjustment Dimensions ] Door Window Adjustment Dimensions.






A - Possible Adjustment - Door Bottom, Rear

• For positioning the upper edge of the door window on the seal in the roof area.

• Accessible from outside, it is not necessary to remove the door trim.

- 1 - Adjusting pins

- 5 - Door window

- To adjust, loosen the locking nut - 2 - and rotate the adjusting pins - 1 - using a Torx socket wrench.

• Turn left - the door window rotates outward

• Turn right - the door window rotates inward

- Tighten the lock nut after adjusting - 2 -, for the tightening specification refer to=> [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

Door - 3 -

- 4 - Window regulator

B - Possible Adjustment - Door Top, Rear

• For sliding the door window in the door window recess outward or inward.

• Accessible after removing the door trim..

- 1 - Adjusting pins

- 5 - Door window

- To adjust, loosen the locking nut - 2 - and rotate the adjusting pins using a Torx socket wrench.

• Turn left - the door window rotates outward

• Turn right - the door window rotates inward

- Tighten the lock nut after adjusting - 2 -, for the tightening specification refer to=> [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

Door - 3 -

- 4 - Window regulator

C - Possible Adjustment - Door Top, Front

• The front window regulator is stationary, it cannot be adjusted.

- 3 - - Door

- 5 - - Door window

- 6 - - Window regulator nut, tightening specification refer to => [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

D - Possible Adjustment - Door Bottom, Front

• The front window regulator is stationary, it cannot be adjusted.

Door - 3 -

- 6 - - Window regulator nut, tightening specification refer to => [ Window Regulator Motor and Window Regulator Overview ] Window Regulator Motor and Window Regulator Overview.

Height Adjustment

• Adjustment dimensions, gap dimensions, refer to => [ Door Window Adjustment Dimensions ] Door Window Adjustment Dimensions.






A - Possible Adjustment - Door Bottom, Rear

• For positioning the upper edge of the door window - 1 - to the seal on the convertible top.

• Accessible through the holes on the bottom edge of the door. The door trim does not need to be removed.

- To adjust the height, turn the adjusting screw - 2 - using a hex socket wrench.

• On turn = 1 mm adjustment

- 2 - Rear window regulator

B - Possible Adjustment - Door Bottom, Front

• For positioning the upper edge of the door window - 1 - to the seal on the A-pillar.

• Accessible through the holes on the bottom edge of the door. The door trim does not need to be removed.

- To adjust the height, turn the adjusting screw - 3 - using a hex socket wrench.

• On turn = 1 mm adjustment

- 4 - Front window regulator