Driver and Front Passenger Door Control Modules (J386)/(J387)

Driver and Front Passenger Door Control Modules (J386)/(J387)

Removing






- Remove the door trim..

- Open the release and the disconnect the connectors - 1 - and - 2 -.

- Disconnect electrical harness connector - 3 -.

- Disconnect the connector - 2 - on the door control module.

- Press the retaining detent - 5 - in - direction of arrow - and disengage the door control module - 6 - on the door shell.

Installation

Installation is reverse of removal, but note the following:

- Install the door trim..