Entry Assistance Handle With Bracket

Entry Assistance Handle with Bracket

Removing






- Remove the entry assistance trim. Refer to => [ Entry Assistance Trim ] Entry Assistance Trim.

- Remove the front cover with the cushion. Refer to => [ Backrest Cover with Cushion ] Backrest Cover With Cushion.

- Disengage the connecting cable. Refer to => [ Connecting Cable ] Connecting Cable.

- Press the handle - arrow - forward as far as the stop and hold it in that position.

- Remove the bolts - 1 -.

- Remove the handle with bracket - 2 - from the backrest frame entry assistance support plate.

- Disengage the straps - arrows A - on the backrest frame.

Installing

• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components ] Description and Operation.

• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Make sure the connectors are installed all the way in and are secure.

Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery Ground (GND) cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the Diagnostic Trouble Code (DTC) memory must be checked, deleted and checked again. Refer to vehicle diagnostic tester.

Tightening specifications, refer to => [ Entry Assistance, Seatback Release Assembly Overview ] Entry Assistance, Seatback Release Assembly Overview.