Rear Seats

Floor Panel for Bench Seat Mounting Grommets and Wire Frame, Checking and Aligning

Check And Adjust The Floor Panel.






- Check body openings - 1 - for deformations.

- In the case of deformation, readjust the panel with a plastic hammer.

• Remaining minor deformation is permissible.

Check And Adjust The Bench Seat Wire Frame.






• The illustration of the seat foam can deviate from the real bench seat. Regardless of the shape of the seat foam, dimension - a - must be measured between the upper edge of the seat foam and the upper edge of the wire frame.

- Place the bench seat with the cover on a clean stable surface.

- Check dimension - a - on both sides of the seat frame, from the padding to the upper edge of the wire frame. Dimension - a - must be 16 to 22 mm.

- If dimension - a - does not meet the specification, the wire frame must be adjusted to meet the specification. For this purpose evenly adjust the wire frame in the area of the - b motion arrows -.