Tail Lamps

Rear Parking/Fog Lamps and Back-Up Lamps 2

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Special tools, testers and auxiliary items required

• Trim removal wedge (3409)

Removing





- Switch off ignition and remove ignition key.

- Turn light switch into 0 position.

- Pry the cover - 1 - out using a (3409) - arrow -.

- Disconnect the electrical connector - 3 -.





- Remove the nut - 1 - and the clamping bracket - 2 -.

- Remove the bulb socket - 4 - from the housing by press the locking bracket upward - arrows -.

- Remove the tail lamp/fog lamp bulb from the socket.

- Remove the back-up lamp bulb from the socket.

Installing

• Tightening specification, refer to => [ Inner Tail Lamp Assembly Overview ] Inner Tail Lamp Assembly Overview.

Install in reverse order of removal, observing the following:

- Insert the new bulb in the socket without touching the bulb with bare hands.

- Slide the large clamping bracket - 3 - onto the inner tail lamp threaded pins. The guide pins - 2 - and - 6 - must engage in the mounts.





- Tighten the nuts - 1 -.

• When tightening the nuts, the clamping bracket wedges itself onto the rear lid - arrows -.

• Ignore items - 4 and 5 -.