Speech Input Control Module (J507), Through 10.2008

Speech Input Control Module (J507), through 10.2008

The speech input control module is located in the radio (MMI) behind luggage compartment left side trim.

- Switch off all electrical consumers.

- Remove the key.

If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault-Finding" routine in the Vehicle Diagnostic Tester.

Removing

- Remove radio (MMI). Refer to => [ MMI Radio, through 10.2008 ] MMI Radio, Through 10.2008.

- Open cover - 2 - of radio and fold it down - arrow -.






- Carefully pull speech input control module - 1 - out of radio in - direction of arrow -.

Installing

- Perform the installation in reverse order.

- Make sure that harness connector between speech input control module and radio engages correctly in radio.

Perform the following function test:

- Switch on the radio.

- Briefly depress PTT button on multifunction steering wheel.

A "Ping" tone sounds, the speech input system is active.

- Say the command "Help"

Since the radio is active, the speech dialog system responds with "Commands for the radio are...".

Depending on the equipment, other functions can be selected:

- If a telephone is installed, say "telephone".

The speech dialog system switches to the telephone mode.

- Press and hold the PPT button for approximately one second.

The speech dialog system responds with "Cancel" and is deactivated.