Fuse Panel B In Engine Compartment E-Box

Fuse Panel B in Engine Compartment E-Box

Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.

Removing





- With ignition switched off, disconnect battery ground wire. Refer to => [ Battery, Disconnecting and Connecting ] Battery, Disconnecting and Connecting.

- Remove the washer fluid reservoir filler neck. Refer to => [ Windshield Washer Fluid Reservoir Filler Neck ] Windshield Washer Fluid Reservoir Filler Neck.

- Remove the bolts - arrows - and the engine compartment E-box cover.

• Disregard item - 1 -.

- Release the retainers - A arrows - and remove the engine control module - arrow B -.





- Disconnect the electrical connector - 2 - if applicable.





- Disconnect the electrical connectors - 4 - and remove the electrical wire - 3 -.

- Open the retainers - arrow - and remove fuse panel B - 1 -.

- Disengage the engine wiring harness on the E-box and free it up.

- Remove the electrical wire - 5 -.





- Remove the relay - 3 - and control modules - 4 - from fuse panel B.

- Release the retaining clip - arrow -, push the fuse panel - 2 - back and out and disengage it.

- Release the retaining clip and press the auxiliary fuse panel - 1 - back and out.

- Release the retaining clips - arrows - and press the relay carrier - 2 - back and out of the bracket - 1 -.





- Remove fuse panel B from the engine compartment E-box.

Installing

• Tightening specification => [ Fuse panel B in engine compartment
E-box, tightening specifications ] Engine Compartment E-Box, Wire Junction, Fuse Holder and Battery Assembly Overview.

Install in reverse order of removal, observing the following:

- Install the washer fluid reservoir filler neck. Refer to => [ Windshield Washer Fluid Reservoir Filler Neck ] Windshield Washer Fluid Reservoir Filler Neck.

- Connect battery. Required actions => [ Connecting ] Battery, Disconnecting and Connecting.