Bolted Windows
Door Window, Adjusting
• To adjust the door glass, use the side window installation tool (V.A.G 1739) and the Torx(R) T25 screwdriver (T10248).
Special tools, testers and auxiliary items required
• Gauge (T10391)
• Hex Ball Socket (T10058)
• Side Window Installation Tool (V.A.G 1739)
•
Lateral Adjustment
• Adjustment dimensions, refer to => [ Door Window Gap Dimensions ] Door Window Gap Dimensions.
A - Possible Adjustment - Door Bottom, Rear
• For positioning the upper edge of the door window on the seal in the roof area
• Accessible from outside, it is not necessary to remove the door trim.
- 1 - Adjusting pins
- 5 - Door window
- To adjust, loosen the locking nut - 2 - and rotate the adjusting pins - 1 - using a Torx(R) socket wrench.
• Turn left - the door window rotates outward.
• Turn right - the door window rotates inward.
• Tighten the locking nut after adjusting.
- Tighten the locking nut - 2 - after adjusting it.
- 2 - Locking nut - 9 Nm
Door - 3 -
- 4 - Window regulator
B - Possible Adjustment - Door Top, Rear
• For sliding the door window in the door window recess outward or inward
• Accessible after removing the door trim.
- 1 - Adjusting pins
- 5 - Door window
- To adjust, loosen the locking nut - 2 - and rotate the adjusting pins using a Torx socket wrench.
• Turn left - the door window rotates outward.
• Turn right - the door window rotates inward.
- Tighten the locking nut - 2 - after adjusting it.
- 2 - Locking nut - 9 Nm
Door - 3 -
- 4 - Window regulator
C - Possible Adjustment - Door Top, Front
• The front window regulator is stationary, it cannot be adjusted.
- 3 - - Door
- 5 - - Door window
- 6 - - Window regulator nut - 9 Nm
D - Possible Adjustment - Door Bottom, Front
• The front window regulator is stationary, it cannot be adjusted.
Door - 3 -
- 6 - Window regulator nut - 9 Nm
Height Adjustment
• Adjustment dimensions, refer to => [ Door Window Gap Dimensions ] Door Window Gap Dimensions.
A - Possible Adjustment - Door Bottom, Rear
• For positioning the upper edge of the door window on the seal in the rear roof area
• Accessible through the holes on the bottom edge of the door. The door trim does not need to be removed.
- 1 - Window regulator
- 2 - Adjusting screw
- To adjust the height, turn the adjusting screw - 2 - using a 4 mm hex socket wrench.
• 1 turn = 1 mm adjustment
- 3 - Door window
B - Possible Adjustment - Door Bottom, Front
• For positioning the upper edge of the door window on the seal in the front roof area
• Accessible through the holes on the bottom edge of the door. The door trim does not need to be removed.
- 1 - Window regulator
- 3 - Door window
- 4 - Adjusting screw
- To adjust the height, turn the adjusting screw - 4 - using a 4 mm hex socket wrench.
• 1 turn = 1 mm adjustment