Peripheral Camera Control Module (J928)

Peripheral Camera Control Module (J928)

The peripheral camera control module - 1 - is located under the right front seat.

- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Use the Vehicle Diagnostic Tester.

- Turn off the ignition and all electrical consumers and remove the ignition key.

Removing

- Move the floor covering to the side..

- Open the E-box cover - 1 -.






- Release and disconnect the connectors - arrows - from the peripheral camera control module - 2 -.

The peripheral camera control module - 2 - is just clipped inside the E-box.






- Press the retainer to the side the remove the peripheral camera control module - 2 - from the E-box.

Installing

- Install in reverse order of removal.

- Perform a calibration. Refer to => [ Peripheral View Camera System, Calibrating ] Peripheral View Camera System, Calibrating.

Component location overview for the tightening specification and installation instructions, refer to => [ Peripheral View Camera System Component Location Overview ] Peripheral View Camera System Component Location Overview.