Night Vision Camera (R212) Mount

Night Vision Camera (R212) Mount

Removing






- Remove the lock carrier cover. Refer to => [ Lock Carrier Cover ] Lock Carrier Cover.

- Disconnect electrical harness connector - 1 -.

- Remove the screws - 2, 3, 5 and 6 - and then remove the mount - 4 - with the Night vision system camera (R212).

- Open the clamp - 7 - - arrow - and remove the windshield washer fluid hose.

- If the mount is being replaced, then remove the night vision system camera.

Installing

• Tightening specifications, refer to => [ Bumper Cover Overview ] Bumper Cover Overview.

Install in reverse order of removal. Note the following:

- Install the night vision system camera.

- Install the lock carrier cover. Refer to => [ Lock Carrier Cover ] Lock Carrier Cover.