Front Wheel Housing Liner

Front Wheel Housing Liner

Removing






- Remove the driveshaft cover. Refer to => [ Driveshaft Cover ] Driveshaft Cover.

- Remove the expanding rivets - 2 -.

- Remove the nuts - 3 - and bolts - 1 -.

- Remove the bolt - 4 - and then disengage the bracket - 5 - on the fender.

- Remove the clip - 7 - from the wheel housing liner - 6 -.

- To remove the clips - 3 -, unlock the release lever - 2 - with needle nose pliers in - direction of arrow A - and push it off the pin - 1 - in - direction of arrow B -.






- Remove the wheel housing liner.

Installing

• Tightening specifications, refer to => [ Wheel Housing Liner Overview ] Wheel Housing Liner Overview.

Install in reverse order of removal. Note the following:

- Make sure the clip is secure after installing it.

- Install the driveshaft cover. Refer to => [ Driveshaft Cover ] Driveshaft Cover.