Harness Connectors, Disconnecting and Connecting
Harness Connectors, Disconnecting and Connecting
• The connector station is located in the vehicle floor under the front seat area.
Special tools, testers and auxiliary items required
• Trim removal wedge (3409)
• Airbag adapter (VAS 6282)
Separating
Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.
- Push the headrest into the lowest position.
- Move the front seat all the way to the rear and then into its highest position.
- Disconnect the ground cable from the battery with the ignition on.
- Unclip cover - 1 - in the front using the trim removal wedge (3409) and remove cover in - direction of arrow - from the connector station - 2 -.
- Remove wiring bracket - 3 - at the top from the connector station by releasing retaining tabs.
• The number of connectors may vary depending on the equipment. The description shows the version with the most equipment.
Before handling pyrotechnical components (for example, disconnecting the connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.
- Disconnect side airbag electrical harness connector - 1 - by releasing retaining tabs.
- Connect airbag adapter connector (VAS 6282) to the side airbag harness connector => [ Airbag Adapter VAS 6282, Connecting ] Airbag Adapter VAS 6282, Connecting.
- Vehicles with seat heating: disconnect the connector - 2 - from the seat heating.
- Disconnect seat heater voltage supply electrical harness connector - 4 - by releasing retaining tabs.
- Disconnect belt latch electrical harness connector - 5 - by releasing retaining tabs.
Connection
• Follow all safety precautions when working on pyrotechnic components. Refer to => [ Restraint System Components, Safety Precautions and Testing Procedures ] Description and Operation.
• Before handling pyrotechnical components (for example, connecting electrical connector), the person handling them must "discharge static electricity". For example, by briefly touching the door striker pin.
Connecting the electrical wiring harnesses happens in reverse order, noting the following:
• Make sure the connectors are installed all the way in and are secure.
Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.
When working on vehicles with the ignition turned on or where the engine has been started, there is a risk of unintentional engine start and of being poisoned by gas in closed areas. There is a risk of clothes and body parts being pulled or getting stuck.
Perform the following steps before turning on the ignition:
• Move the selector lever into P.
• Activate the parking brake
• Turn the ignition off.
• Open the hood.
• Connect the charger unit i.e., battery charger (VAS 5095A) to the battery jump start terminal for the 12V vehicle electrical system.
• Switch the ignition on.
- Connect the battery ground cable with the ignition turned on.
• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again.