Seat Heating Control Module J882

Seat Heating Control Module J882

Removing






- Remove rear seat bench. Refer to => [ Rear Bench Seat ] Rear Bench Seat.

- Slightly lift the sill panel strip above the control module - 3 - and remove the control module with the mount - 1 - from the wiring guide - arrow -.

• In addition, the mount for the control module is bonded to the body with an adhesive pad.

- Disconnect the connector - 2 - and remove the seat heating control module.

Installation






- Install the control module - 1 - into the mount - 2 - and remove the protective backing from the adhesive pad - 3 -.

- Install the control module with the mount into the wiring guide and press it forcefully to the body.

Installation is performed in reverse order of removal, noting the following:

Information for installation: for example tightening specifications, replacing body parts, refer to => [ Rear Seat Bench Assembly Overview ] Rear Seat Bench Assembly Overview.