Diagram 46/3 (Tracks 15-28)

IMPORTANT NOTE:
This manufacturer uses "Track" style wiring diagrams.
For information on how to use these diagrams effectively, please refer to Diagram Information and Instructions. Diagram Information and Instructions


Image processing control module, Camera control module, Directional stabilization assistance windshield defogger





ws = white
sw = black
ro = red
br = brown
gn = green
bl = blue
gr = grey
li = lilac
ge = yellow
or = orange
rs = pink

G397 - Rain/light recognition sensor

J104 - ABS control module Control Modules in Front Part Of Vehicle

J533 - Data bus on board diagnostic interface Control Modules in Rear Part Of Vehicle

J851 - Image processing control module Control Modules in Front Part Of Vehicle

J852 - Camera control module Control Modules in Front Part Of Vehicle Lane Assist Camera Control Module And Lens Trim

ST1 - Fuse panel 1

SB11 - Fuse 11 (on fuse panel B) Overview Of Fuses

T4u - 4-pin connector, near the interior rearview mirror

T12a - 12-pin connector Camera Control Module -J852-

T12i - 12-pin connector Image Processing Control Module -J851-

T32b - 32-pin connector Locations

T47 - 47-pin connector Locations

Z67 - Directional stabilization assistance windshield defogger

(44) - Ground connection on A-pillar, lower left

(367) - Ground connection 2 (in main wiring harness)

(370) - Ground connection 5 (in main wiring harness)

(811) - Ground connection (in windshield defogger wiring harness)

(B565) - Connection 32 (in main wiring harness)

* - Only for vehicles with adaptive cruise control (ACC)

*2 - Refer to applicable wiring diagram for fuse positions

*3 - Refer to applicable standard equipment wiring diagram

*4 - Data bus wire (FlexRay bus)

Previous Diagram 46/2 (Tracks 1-14)

Next Diagram 46/4 (Tracks 29-42)