Procedures

Engine, Securing to Engine and Transmission Holder

Special tools, testers and auxiliary items required

• Engine Sling (2024 A)

• Engine and Transmission Holder (VAS 6095) with Universal Mounting (VAS 6095/1) and Bracket for V6 FSI Engine, Audi A6 (VAS 6095/1-5)

• Shop Crane (VAS 6100)

• Lift Arm Extension for Workshop Hoist (VAS 6101)

• Joint Support (VAS 6131/13-7)

Securing

Risk of accident!

• The engine may be transported only in the manner described and without the transmission.

• The engine/transmission subassembly is removed and the engine and transmission are separated.

• Engine secured with the (VAS 6131/13-7).

- Remove the ribbed belt from the A/C compressor. Refer to => [ Ribbed Belt ] Ribbed Belt.






- Remove A/C compressor.

- Engage the (2024 A) on the engine lifting eyes and on the shop crane as shown in the illustration.






• To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the illustration.

Risk of accident.

• Lifting hooks and alignment pins on lifting tackle must be secured with securing pins - arrows -.

- Tension engine slightly with shop crane, do not raise.

- Disconnect the left and right connectors - 2 - from the electrohydraulic engine mount solenoid valve.






- Remove the right nut - 1 - and remove the bracket with the wiring harness from the subframe.

- Remove the left and right bolt - 2 - from the engine mount.






• Ignore - 1 -.

- Remove the (VAS 6131/13-7) from engine.






- Raise engine from engine carrier.

- Remove the bolts - arrows - and the left engine support with the A/C compressor bracket.






- Remove the nut - 1 - and free up the Ground (GND) wire at the engine support.






- Remove the bolts - arrows - and the right engine support.

- Secure the starter on the engine.

- Secure the engine to the (VAS 6095/1) and (VAS 6095/1-5) on the (VAS 6095) to 40 Nm, as illustrated.