Right Temperature Door Motor (V159)

Right Temperature Door Motor (V159)

Removal

- Note the general information => [ General Control Motor Information ] General Control Motor Information.

- Move the right front seat all the way back.

- Switch off the ignition.

- Remove the bracket for the control motors (V109) / (V111). Refer to => [ Bracket For Control Motors (V109)/(V111) ] Bracket For Control Motors (V109)/(V111).

- Label the electrical harness connector and control motor.






- Remove the bolts - 1, 4 -.

- Remove the control motor - 2 - from the shaft - 5 - for the actuator lever.

- Disconnect the electrical harness connector - 3 -.

Installation

Installation is done in reverse order, observe the following:

Risk of damage to the control motor.

• Do not turn the control motor mount by hand if the electrical harness connector is not connected - this can damage the electronics in the control motor.

• Only rotate the control motor mount with the electrical harness connector connected by carefully and slowly turning the mount by hand.

- The mount - E - of the control motor - C - can only be installed in one position on the actuator lever - D -.






• The control motor mount must be opposite the actuator lever as shown in the figure.

• If the mount and actuator lever are not across from one another, the mount must be turned in the control motor. Note the general information => [ General Control Motor Information ] General Control Motor Information.

- Connect the electrical harness connector - A -.

- Place the control motor on the air distributor housing. The actuator lever must engage in the mount.

• There must not be any play in the connection between the control motor and the actuator lever.

- Tighten the screws - B -. Refer to => [ Basic Version - Add On Parts of A/C Unit Overview ] Basic Version - Add On Parts of A/C Unit Overview.

- Install the wiring harness - F - so that it cannot come in contact with any moving parts (for example, the lever of the control motor).

- Install the bracket for the control motors (V109) / (V111). Refer to => [ Bracket For Control Motors (V109)/(V111) ] Bracket For Control Motors (V109)/(V111).

After completion of the repair work, perform the following work on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function:

- Read out the event memory and erase any displayed entries.

- Perform the basic setting.

- Perform the output diagnostic test mode.