Right Rear Upper Body Vent Motor (V316)

Right Rear Upper Body Vent Motor (V316)

Removal

- Note the general information. Refer to => [ General Control Motor Information ] General Control Motor Information.

- Remove the rear vents..

- Remove the rear vent air guide. Refer to=> [ Vent Air Guide ] Vent Air Guide.

- Label the electrical harness connector and control motor.






- Disconnect the electrical harness connector - 3 -.

- Remove the bolts - 1, 4 -.

- Remove the control motor - 2 - from the shaft - 5 - for the door.

Installation

Installation is done in reverse order, observe the following:

Risk of damage to the control motor.

• Do not turn the control motor mount by hand if the electrical harness connector is not connected - this can damage the electronics in the control motor.

• Only rotate the control motor mount with the electrical harness connector connected by carefully and slowly turning the mount by hand.

- The mount of the control motor - 3 - can only be installed in one position on the shaft - 5 -.






• The control motor mount must be opposite the shaft as shown in the figure.

• If the mount and shaft are not across from one another, the mount must be turned in the control motor. Note the general information => [ General Control Motor Information ] General Control Motor Information.

- Connect the electrical harness connector - 1 -.

- Place the control motor on the air distributor housing. The actuator lever must engage in the mount - 4 - - arrow -.

• There must not be any play in the connection between the control motor and the shaft.

- Tighten the screws, refer to=> [ Comfort Version - Add On Parts of the A/C Unit Overview ] Comfort Version - Add On Parts of the A/C Unit Overview.

- Install the wiring harness - 2 - so that it cannot come in contact with any moving parts (for example, the lever of the control motor).

- Install the rear vent air guide. Refer to=> [ Vent Air Guide ] Vent Air Guide.

- Install the rear vents..

After completion of the repair work, perform the following work on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function:

- Read out the event memory and erase any displayed entries.

- Perform the basic setting.

- Perform output Diagnostic Test Mode (DTM).