Evaporator Vent Temperature Sensor (G263)

Evaporator Vent Temperature Sensor (G263)

Removal






- Remove the glove compartment.

- Remove the footwell vent on the front passenger side. Refer to => [ Right Footwell Vent Air Guide - Front Passenger Side ] Right Footwell Vent Air Guide - Front Passenger Side.

- Disconnect the electrical connector - A -.

- Turn the vent temperature sensor - B - counterclockwise - arrow - and pull it out of the mount - D -.

Installation

Installation is done in reverse order, observe the following:

- Replace a damaged or defective sealing ring - C -.

- Install the footwell vent on the front passenger side. Refer to=> [ Right Footwell Vent Air Guide - Front Passenger Side ] Right Footwell Vent Air Guide - Front Passenger Side.

After completion of the repair work, perform the following work on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function:

- Read out the event memory and erase any displayed entries.