LED Headlamp Power Output Module 4 Right/Left (A30)/(A34)

LED Headlamp Power Output Module 4 Right/Left (A30)/(A34)

Danger of causing damage to the vehicle electronics.

• Requirement: Make sure nothing, especially metal or other light weight particles, can get into the headlamp housing.

• Make sure also no oil, grease, silicone or other such materials can get into an open headlamp, otherwise they can turn into steam and fog up the headlamp.

• Touching electronic circuits with bare hands can lead to migration.

• ESD (electro static discharge) protection: Always follow DIN EN 613-40-5-1 when handling.

• Do not use any components or electronics that have fallen down.

Removing






- Remove the front wheel housing liner.

- Remove the bolts - arrows -.

- Remove the housing cover - 1 -.

- Remove the screws - arrows - and the frame - 1 - from the housing cover - 2 -.






- Remove the power output stage - 2 - from the housing cover - 1 -.






- Press the releases - arrows - and disconnect the connector.

Installing

• Tightening specification, refer to=> [ LED Headlamp Overview ] LED Headlamp Overview.

Install in reverse order of removal. Note the following:

- Close the housing cover and tighten the bolts.

- Install the front wheel housing liner..