Fuel Tank With Attachments Overview
Fuel Tank with Attachments Overview
1 Bolt
• 20 Nm
2 Suspended Mount
• For exhaust system
• Individual components of the mount, refer to => [ Tensioning Strap Mount Individual Parts ]
3 Mounting Strap
• Individual components of the mount, refer to => [ Tensioning Strap Mount Individual Parts ]
4 Adjusting Buffer
• Individual components of the mount, refer to => [ Tensioning Strap Mount Individual Parts ]
5 Spacer Sleeve
• Individual components of the mount, refer to => [ Tensioning Strap Mount Individual Parts ]
6 Fuel Line
• From the fuel pressure regulator to the engine
• Do not kink
• Clipped to the fuel tank
• To disconnect, press release button on connection piece
7 Protective Plate
• For fuel filler tube
8 Bolt
• 20 Nm
9 Bolt
• 3.5 Nm
10 Overflow Hose
11 Fuel Filler Door Insert
12 Cover
• Turn until it clicks and locks.
• Attached to the fuel filler door insert with a permanent fastener.
13 Bolt
• 20 Nm
• To attach the fuel filler neck
14 Ground Connection
• For fuel filler tube
• For discharging electrostatic charge, refer to => [ Fuel Filler Tube Ground Connection ]
15 Fuel Tank
• Removing and installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank With Attachments
16 Vent Line
• To the EVAP canister
• Do not kink
• To disconnect, press release button on connection piece
17 Heat Shield
• For the fuel tank
18 Lock Washer
• 2 Nm
• For heat shield
19 Carrier Plate
20 Bolt
• 20 Nm
21 Heat Shield
• For the fuel tank
22 Lock Washer
• 2 Nm
• For heat shield
23 Expanding Clip
Fuel Filler Tube Ground Connection
- Route the ground connection as illustrated.
- Make sure the following connectors are secure:
• Ground connector - 2 - on the threaded ring - 1 - on the fuel filler tube.
• Ground connector - 6 - on the fuel filler tube cover.
- Attach the ground connection contact - 4 - to the hole in the fuel tank - 3 - and then install the spacer - 5 -.
Risk of explosion due to electrostatic charge.
• After installing, check electrical connection on the fuel filler neck metal ring to an empty spot on the body using an Ohm meter.
• Specified value: Approximately 0 ohms.
Tensioning Strap Mount Individual Parts
1. Exhaust system mount - only right front inside
2. Adjusting buffer
3. Mounting strap
4. Spacer sleeve
5. Bolt