Connector Station, Right A-Pillar
Connector Station, Right A-Pillar
Removing
- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.
- Remove the front sill panel.
- Push the clip in - direction of arrow - and disengage the connector station - 1 - from the A-pillar.
- Unclip the fuse holder - 2 - from the coupling station.
- Release the retainers - arrows - and remove the relay panel - 2 - from the connector station - 1 - to the rear.
• Check the exact connector assignment in the current wiring diagram.
Installing
Install in reverse order of removal. Note the following:
- Install the front sill panel..
- Connect battery. Required actions, refer to=> [ Connecting ] Service and Repair.