HID Headlamps, Daytime Running Lamp and Parking Lamp Control Module

Daytime Running Lamp and Parking Lamp Control Module

Danger to life due to high voltage.

• Always disconnect the battery wire strap before working on gas-discharge headlamp components marked with yellow high-voltage symbols.

Removing






- Remove the lock carrier cover.

- Right side: remove the air filter housing.

- Remove the bolts - arrows -.

- Remove the control module - 1 - from the headlamp housing.

- Press the release - 2 - and disconnect the connector - 3 -.

- Remove the control module.

Installing

• Tightening specification, refer to => [ HID Headlamps Overview ] HID Headlamps Overview.

Install in reverse order of removal. Note the following:

- Make sure the seal - 4 - between the control module and the headlamp housing is not damaged.

- Right side: install the air filter housing.

- Install the lock carrier cover.