Relay and Fuse Panel In Plenum Chamber E-Box
Relay and Fuse Panel in Plenum Chamber E-Box
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] Service Precautions.
Removing
- Turn off the ignition and disconnect the ground cable from the battery. Refer to => [ Battery, Disconnecting and Connecting ] Service and Repair.
- Remove the washer fluid reservoir filler neck. Refer to=> [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.
- Release the retainer - arrow -, remove the engine control module - 1 - and move it to the side with the wires still connected.
• Disregard item - 2 -.
- Remove the screws - arrows - and remove the cover - 1 - for the right plenum chamber E-box.
- Disconnect the connectors - 1 - and remove the nut - 2 - for the electric wire.
- Open the retainers - arrow - and remove the relay panel and fuse panel - 4 -.
- Remove the nut - 3 - for the electric wire.
- Release the tab - arrow -, push fuse panel A - 2 - to the rear and disengage it from the relay panel - 1 -.
- Open the clip and remove the auxiliary fuse panel - 2 -.
- Open the clips - arrows - and remove the relay - 1 - and the control modules from the relay panels.
- Release the retaining clips - arrows - and press the relay carrier - 3 - back and out of the bracket - 4 -.
- Open the clip - 2 - and remove the connector - 1 -.
Installing
• For the correct tightening specification, refer to => [ Tightening Specification
For The Relay Panel and Fuse Panel Inside The Plenum Chamber E-Box ] Plenum Chamber E-Box, Wire Junction, Fuse Holder and Battery Overview and => [ Plenum Chamber E-Box, Wire Junction, Fuse Holder and Battery Overview ] Plenum Chamber E-Box, Wire Junction, Fuse Holder and Battery Overview.
Install in reverse order of removal. Note the following:
- Install the washer fluid reservoir filler neck. Refer to=> [ Washer Fluid Reservoir Filler Neck ] Washer Fluid Reservoir Filler Neck.
- Connect the battery. Required actions, refer to=> [ Connecting ] Service and Repair.