Peripheral Camera Control Module (J928)

Peripheral Camera Control Module (J928)

The peripheral camera control module - 1 - is located inside the luggage compartment, on the left side and on the rear panel.






- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Using the Vehicle Diagnostic Tester.

- Turn off the ignition and all electrical consumers and remove the ignition key.

Removing

- Remove the luggage compartment rear trim panel..

The peripheral camera control module - 1 - is only clipped to the bracket.






- Unlock and disconnect the connectors from the peripheral camera control module - 1 -.

- Push the retainers - arrow - to the right using a small screwdriver and remove the peripheral camera control module.

Installing

- Install in reverse order of removal.

- Perform a calibration. Refer to => [ Peripheral View Camera System, Calibrating ] Peripheral View Camera System, Calibrating.

Component location overview for the tightening specification and installation instructions refer to => [ Peripheral View Camera System Component Location Overview ] Peripheral View Camera System Component Location Overview.