Rearview Camera System Control Module (J772)

Rearview Camera System Control Module (J772)

The rearview camera system control module - 1 - is located inside the luggage compartment on the rear panel on the left side.






- If control module is replaced, select "Replacement" function for appropriate control module in "Guided Fault Finding".

Use the Vehicle Diagnostic Tester.

- Turn off the ignition and all electrical consumers and remove the ignition key.

Removing

- Remove the luggage compartment rear trim panel..

The rearview camera system control module - 1 - is only wedged inside the bracket.






- Unlock and disconnect the connectors from the rearview camera system control module - 1 -.

- Push the retainers - arrow - to the right using a small screwdriver and remove the rearview camera system control module.

Installing

- Install in reverse order of removal.

- Perform a calibration. Refer to => [ Rearview Camera System, Calibrating ] Testing and Inspection.

Component location overview for the tightening specification and installation instructions refer to => [ Component Location Overview ] Component Location Overview.