Sunroof Shade Motor

Sunroof Shade Motor

Code or perform an adaptation in Guided Function or in Guided Fault Finding in diagnosis address 46 after replacing the roof shade control module (J394) or roof shade control module 2 (J867). Refer to Vehicle diagnostic tester.






1 Electric wire

• Fasten in the bracket - arrows -.

2 Sunroof frame

3 Roof sun shade control module. (J394)

- Remove the sunroof shade frame.

- Remove the screws from the control module and remove it.

- After installing, perform an adaptation. Refer to Vehicle diagnostic tester..

4 Bolt

• 3 Nm

5 Sunroof shade frame

- Move the front and rear sunroof shade into the service position.

- Remove the seal near the frame.

- Disconnect the connector from the motors.

- Remove screws - 4 -.

- Remove the frame upward.

6 Roof shade control module 2 (J867)

- Remove the sunroof shade frame.

- Remove the screws from the control module and remove it.

- After installing, perform an adaptation. Refer to Vehicle diagnostic tester..

7 Bolt

• Torque: 3 Nm