Center Speaker Trim

Center Speaker Trim

• Proceed very carefully when removing and installing because it is relatively easy to damage the speaker trim.

Removing






- Using a small screwdriver, carefully detach the speaker trim - 1 - at the rear retaining tabs with respect to the direction of travel - arrow A -, but pull up only about 10 mm.

Do not lift the speaker trim any higher or the front retaining pins will break off.

- Insert a long screwdriver under the speaker trim at the very front, until it comes into contact directly with the right front retaining pin.

- Carefully rotate the screwdriver - arrow B - until the retaining pin - 1 - disengages from the guide - 2 -.

- Repeat the procedure on the remaining retaining pins.

Installing

Install in reverse order of removal. Note the following:

Installation note: For example tightening specifications, replace components => [ Instrument Panel Assembly Overview ] Instrument Panel Assembly Overview.