Front Axle Camber, Centering

Front Axle Camber, Centering

Camber cannot be adjusted.

Camber can be centered evenly within specified tolerance range by shifting subframe.

- Remove the noise insulation - 1 and 2 -..






- If equipped, loosen the left and right bolts - arrows - from the transmission mount.






• It is necessary to loosen the threaded connection on the transmission mount to prevent putting too much tensions on the mount.

- Loosen the bolt - 2 -, if equipped.






- Remove the left and right bolts - 1 through 6 - from the subframe diagonally and in steps.






• If the subframe is moved, the front of the vehicle must be lifted at the jack points using an axle lift.

- Using a plastic-coated tire iron, slide the subframe with the engine mount and stabilizer bar in the appropriate location.






- Push in the center of the subframe near the lower control arm between the subframe and the body longitudinal member.

If you do not have a plastic-coated tire iron, wrap a standard tire iron in adhesive tape.

- The vehicle must be bounced several times at the front axle before checking the camber values.

Do not damage any parts!

Axle alignment specified values. Refer to => [ Wheel Alignment Specified Values ] [1][2]Alignment.

- Tighten the left and right bolts - 1 through 3 - from the subframe diagonally and in steps.






- Tighten the bolts - 1 through 6 -. Refer to => [ Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Heat Shield Overview ] Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Heat Shield Overview.






- If equipped, loosen the left and right bolts - arrows - from the transmission mount.






- Tighten the bolt - 2 -, if equipped. Refer to => [ Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Heat Shield Overview ] Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Heat Shield Overview.






- Check the camber value one more time. Refer to => [ Wheel Alignment Specified Values ] [1][2]Alignment.

Tightening specifications, refer to => [ Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Heat Shield Overview ] Subframe, Crossbrace, Stabilizer Bar, Coupling Rod and Subframe Heat Shield Overview

- Install noise insulation..

Every time camber is corrected, axle alignment values should be checked.