Fuel Tank with Attachments Overview
Fuel Tank with Attachments Overview
1 Bolt
• 23 Nm
2 Lock Washer
• For heat shield
3 Fuel Line
• Only on the rest of the world vehicles with an auxiliary heater
4 Fuel Line
• From the fuel pressure regulator to the engine
• Do not kink
• Clipped to the fuel tank
• To disconnect, press release button on connection piece
5 Bolt
• 23 Nm
6 Bracket
• Bolted to the fuel tank
7 Mounting Strap
• Individual components of the mount, refer to => [ Tensioning Strap Mount Individual Parts ]
8 Chafe Protection
9 Nut
• 2.5 Nm
10 Cover
• Turn until it clicks into place
• Attached to the fuel filler door insert with an permanent fastener
11 Bolt
• 23 Nm
• To attach the fuel filler neck
12 Vent Line
• To the EVAP canister
• Do not kink
• To disconnect, press release button on connection piece
13 Separating Point
• For breather line
14 Carrier Plate
15 Bolt
• 23 Nm
16 Fuel Tank
• Removing and installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank with Attachments
17 Mounting Strap
18 Bolt
• 23 Nm
19 Fuel Tank Heat Shield
20 Bolt
• 23 Nm
21 Fuel Tank Heat Shield
Fuel Filler Tube Ground (GND) Connection
- Route the GND wires - 1 and 2 - as illustrated.
- Make sure the terminals on the GND connections are securely fastened to the shield and the metal ring on the fuel filler tube.
Risk of explosion due to electrostatic charge.
• After installing, check electrical connection on the fuel filler neck metal ring to an empty spot on the body using an Ohm meter.
• Specified value: approximately 0 ohms.
Tensioning Strap Mount Individual Parts
1. Exhaust system mount - only right front inside
2. Grommet
3. Mounting strap
4. Spacer sleeve
5. Bolt