Selector Lever Release Button (E681) and Selector Lever Transmission Range Position Display Unit (Y26)

Selector Lever Release Button (E681) and Selector Lever Transmission Range Position Display Unit (Y26)

Special tools, testers and auxiliary items required

• Inner Torx(R), size T6

• Commercially available torque wrench, torque 0.25 Nm, for example, made by Stahlwille, No. 775/12 , range 0.2 - 1.2 Nm

Removing

- Ignition turned off

- Remove the key.

- Wait until the lamp in the selector lever transmission range position display unit - 2 - goes out.






• The selector lever release button and the selector lever transmission range position display unit are a unit - 1 -. They can only be replaced together.






- Pull the upper selector lever handle - 1 - upward.

- Remove the three screws - arrows - on the bottom of the upper selector lever handle.






- Remove the selector lever release button and the selector lever transmission range position display unit - 3 - carefully.






- Remove the cover - 1 - carefully.

Installing

Install in reverse order, paying attention to the following:

• For the correct tightening specifications, refer to => [ Selector Mechanism Overview ] Selector Mechanism Overview.

- Install the selector lever release button and the selector lever transmission range position display unit - 3 - into the upper selector lever handle - 2 -.

- Install the cover - 1 -.

- Install the three screws - arrows - carefully.






Danger of damaging the components.

• The tightening specification for the three screws if very small. Refer to - item 4 - => [ (Item 4) Bolt ] Selector Mechanism Overview.

- Make sure the three clips - 1 - fit correctly into the bottom of the upper selector lever handle. Push them in if necessary.

- Attach the upper selector lever handle - 1 - to the lower selector lever handle section - 2 -.






- Selector mechanism, checking, refer to => [ Selector Mechanism, Checking ] Selector Mechanism, Checking.