Rear Cover Plate

Rear Cover Plate

Removing

- Raise vehicle.

- Remove wheels.

- Remove the rear brake disc. Refer to => [ Brake Disc ] Brake Disc.

- Hang the brake caliper with the brake carrier on the body with wire.

Do not let the brake caliper with the brake carrier hang on the brake hose. Do not support the weight with the brake hose.

Do not actuate the brakes or the electromechanical parking brake when the brake caliper is removed.

- Remove the cover plate bolts - 1 -.





- Remove cover plate - 2 -.

Installing

- Mount the cover plate - 2 -.

- Install and tighten the bolts - 1 -.

- Install the rear brake disc. Refer to => [ Brake Disc ] Brake Disc

• Make sure the brake hose is routed correctly. Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

- Clip the electrical wires into the bracket on the stub axle carrier.

• Make sure the wire are installed correctly in the brackets on the stub axle carrier so that they can come out of the brackets on their own.

- Install wheels.

Wheel bolt tightening specifications, refer to => Wheel and Tire Guide Specifications.

- Lower vehicle.

• After installing, press the brake pedal several times firmly to properly seat brake pads in their normal operating position.

• Make sure the brakes are working correctly before driving the vehicle for the first time.