Engine Coolant Temperature Sensor

Engine Coolant Temperature Sensor

Removing

• Engine cold.

- Briefly open the coolant reservoir cap to reduce the residual pressure in the coolant system.






- Remove the engine cover - arrows -.






- Free up the coolant hose - 2 - - arrow -.






- Open the clamps - 1 - and - 3 - and remove the air guide pipe.

- Disconnect the connector - 1 -.






• Lay a cloth below to catch escaping coolant.

- Remove the clip - 2 - and then remove the engine coolant temperature (ECT) sensor (G62).

Installing

Install in reverse order of removal. Note the following:

• Replace O-ring.

• To prevent coolant loss, immediately insert new engine coolant temperature (ECT) sensor in support.

- Install the air guide pipe.

- Check the coolant level => [ Check the coolant level. ] Procedures.