Throttle Valve Control Module

Throttle Valve Control Module

Removing

- Remove engine cover.

- Unclip the fuel supply line - 2 -.

- Loosen the clamps - 1 and 3 - and remove the right air guide pipe.





- Loosen the clamps - 1 and 3 - and remove the left air guide pipe.





- Remove the vacuum lines - arrows - from the intake connection.

- Remove the bolts - 4 - and remove the crankcase ventilation.





- Remove the hose - 2 - from the EVAP canister purge regulator valve 1 (N80).

- Disconnect the connectors - 1 and 3 -.

- Remove the EVAP canister purge regulator valve 1 from the bracket and move it to the side.





- Open the clamp on the intake connection.

- Remove both bolts - arrows - from the intake connection.





- Remove the intake connection.

- Remove bolts - arrows - and remove throttle valve control module (J338).





Installing

Installation is in reverse order.

• Tightening specifications, refer to => [ Intake Manifold Assembly Overview ] Intake Manifold Assembly Overview

Perform an adaptation using the vehicle diagnosis tester under guided functions after replacing.