Heated Oxygen Sensor 2 In Front of Catalytic Converter

Heated Oxygen Sensor 2 In Front of Catalytic Converter

Special tools, testers and auxiliary items required

• Ring Spanner 7-Piece Set (3337)

Removing

• All cable ties opened or cut during engine removal must be reinstalled at the same locations during installation.

- Remove engine cover.

- Loosen the clamps - 1 and 2 - and remove the left air guide pipe.





- Separate the electrical connector - 3 -.





- Remove the heated oxygen sensor 2 (G108) - 1 - using a tool from the (3337).

Installing

Installation is in reverse order of removal, note the following:

• New oxygen sensors are coated with assembly paste; the paste must not get into slots of oxygen sensor body.

• For a used oxygen sensor, only coat threads with hot bolt paste. This paste must not come into contact with oxygen sensor slots. Hot bolt paste, refer to the electronic parts catalog ETKA

• Electrical wire of oxygen sensor must always be secured in the same position when installing so that contact with the exhaust pipe is avoided.

• During installation, all cable ties must be installed at the same location.

• Tightening specification, refer to => [ Oxygen Sensors Assembly Overview ] Oxygen Sensors Assembly Overview.