Access/Start Authorization Switch (E415), through June 2010

Access/Start Authorization Switch (E415), through June 2010

• Induction coil for immobilizer is secured to the Access/Start Authorization Switch and cannot be replaced separately.

• If induction coil is malfunctioning, the Access/Start Authorization Switch must be replaced.

• If access/start authorization switch is replaced, no adaptation of immobilizer is necessary.

• Lock in access/start authorization switch is not coded mechanically.

• Keys must therefore not be replaced when access/start authorization switch is replaced; present keys continue to match.

Removing






- Remove the instrument panel cover in the center..

- Remove the bolts - A arrows -.

- Remove the mount - 4 - and the access/start authorization switch.

- Disconnect the connector - 1 - by sliding the retainer - 2 - up - arrow B - and pressing the release- 3 - toward the inside.

- Remove bolt - 2 -.






- Release the tab - 4 - - arrow - and remove the access/start authorization switch - 1 - from the mount - 3 -.

- Remove the trim and remove the access/start authorization switch..

Installing

• Tightening specification, refer to => [ Steering Column Switch Module, Electronic Ignition Lock and Induction Coil Overview ] Service and Repair.

Install in reverse order of removal, observing the following:

- Install the center instrument panel cover..