Image Processing Control Module (J851)

Image Processing Control Module (J851)

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1783)

• Vehicle Diagnostic Tester with diagnostic cable

Removing

The image processing control module is located in the footwell in front of the front passenger seat.

If the image processing control module is replaced, then the program must be started on the vehicle diagnostic tester in "Guided Functions".

- Remove the sill panel strip..

- Remove the floor mat.

- Remove the foot rest..

- Loosen the front passenger seat and push it to the rear with the wires still connected.

- Disengage the floor covering and push it to the side.

- Remove the nuts - arrows -.






- Remove the bolts - 1 through 4 - and remove the bracket - 5 - from the image processing control module.

- Unlock the connector - 1 and 2 - and disconnect it from the image processing control module - 3 -.






Installing

Install in reverse order of removal. Note the following:

Tightening specifications nuts - arrows - 2.5 Nm






Tightening specifications bolts - 1 through 4 - 8 Nm

If the image processing control module was replaced, then the program must be started on the vehicle diagnostic tester in "Guided Functions".