Humidity Sensor (G355), without Headlamp Assistant

Humidity Sensor (G355), without Headlamp Assistant

Removing






- Remove front interior/reading light, refer to => [ Front Interior Lamp/Reading Lamp ] Front Interior Lamp/Reading Lamp.

- Unclip the lower cover - 2 - on the windshield and on the rear cover - 1 - - arrow -.

- Turn the base of the interior rear view mirror counter-clockwise and remove it from the retaining plate.

- Release the retaining tabs - 1 - and - 2 - with a screwdriver - 3 -.






- Disengage the rear cover - 4 - - arrows -.

- Release the tabs - arrows - and carefully fold the upper cover - 2 - upward just a little.






- Disengage the retainer - 1 - on the front cover - 3 -.

- Remove the upper cover.

- Spread the front cover - 1 - apart slightly on both sides - arrows - and remove it from the interior rear view mirror base - 2 -.






- Disconnect the electrical connector - 2 -.






- Using a small screwdriver - 3 -, carefully press the humidity sensor - item 4 - off the cover - 1 - - arrow - and remove it upward.

Installing

Install in reverse order of removal, observing the following:

- Carefully place humidity sensor in side guides.

• The cover cannot be installed if the humidity sensor is not inserted correctly.

- Install the interior rear view mirror.

- Install the front interior lamp/reading lamp, refer to => [ Front Interior Lamp/Reading Lamp ] Front Interior Lamp/Reading Lamp.