Rear Brakes Assembly Overview

Rear Brakes Assembly Overview

• Only install complete repair kit.






1 Electrical Connection

• Connection for the motor.

• Connection for the brake pad wear indicator wire.

• Install in the bracket.

• Make sure the bracket is installed correctly.

2 Wire for Brake Pad Wear Indicator

• Removing and installing, refer to => [ Brake Pad Wear Display Wire ] Brake Pad Wear Display Wire.

3 Bleed Screw

4 Electromechanical Parking Brake Motor

• Removing and installing, refer to => [ Electromechanical Parking Brake Motor ] Service and Repair.

5 Ribbed Bolt

• Always replace.

• When loosening and tightening, counter-hold at guide pin.

• 35 Nm

6 Brake Caliper

• Do not unscrew brake hose when replacing brake pad.

• Brake caliper, servicing, refer to => [ Rear Brake Caliper Piston ] Rear Brake Caliper Piston.

• Removing and installing, refer to => [ Brake Caliper and Brake Carrier ] Brake Caliper and Brake Carrier.

• Replacing, refer to => [ Brake Caliper ] Brake Caliper.

7 Bolt

• 5 Nm

8 Brake Disc

• Must always be replaced together on both sides of vehicle.

• Remove brake caliper before removing.

• Brake disc allocation, refer to => [ Brakes ] Brakes.

• Removing and installing, refer to => [ Brake Disc ] Brake Disc.

• Replacing, refer to => [ Brake Disc, Replacing ] Brake Disc, Replacing.

9 Brake Pads

• Must always be replaced together on both sides of vehicle.

• Removing and installing, refer to => [ Brake Pads ] Brake Pads.

• Brake pad allocation, refer to => [ Brakes ] Brakes.

• Inner brake pad with brake pad wear display wire.

10 Brake Pad Spring

• Always replace when pads are replaced.

• Make sure it fits correctly in the brake carrier.

11 Brake Carrier with Guide Pins and Protective Cap

• Supplied as an assembled replacement part with sufficient grease on guide pins.

• If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.

• For brake rotor removal, removing the brake carrier.

12 Brake Carrier Bolt

• 100 Nm + 90° turn

• Always replace.

13 Bracket

14 Bracket Bolt

• 10 Nm

15 Brake Hose

• Brake hose in brake caliper: 19 Nm

• Brake hose to brake pipe line: 12 Nm

• Make sure the brake hose is routed correctly. Make sure the brake hose is not blocked, bent or rubbing against the vehicle.

16 Retaining Clip

17 Bolts for the Motor

• 12 Nm

Brake cover plate, removing and installing, refer to => [ Rear Cover Plate ] Rear Cover Plate.