Rear Door Components

Mounting Bracket

Special tools, testers and auxiliary items required

• Pry Lever (80 - 200)

Removing

- Remove the door trim..

- Remove the door cover. Refer to => [ Door Cover ]








There is a risk of malfunction. When removing and installing, make sure the actuating link is not kinked or damaged.

- Turn the actuating link on the lever - 1 - 90° in the - direction of arrow A - and remove it from the bracket - 2 -.

- Rotate the actuating link on the door lock operating lever - 3 - in the - direction of arrow B -.

• The actuating link must be aligned with the opening on the operating lever.

- Disengage the actuating link from the operating lever.

- Remove door handle. Refer to => [ Door Handle ] Rear Door Handle.

- Disengage the electrical wire on the mounting bracket - arrow - if applicable.





- Free up the electrical wire spiral clip - 1 - using the pry lever (80 - 200).

• Use a soapy solution if necessary make removal easier.

- Remove the bolt - 3 - and the mounting bracket - 2 -.

Installation





- Engage the actuating link - 3 - in the door lock operating lever - 2 -.

- Insert the actuating link in the bracket - 1 - and rotate the lever - 4 - 90° - arrow -.

• The lever must engage audibly with the locking tab on the bracket.