Tires, With Tire Pressure Monitoring System

Tires, with Tire Pressure Monitoring System

• Replace the nickel-plated valve insert each time a tire is changed. Allocation, refer to the Electronic Parts Catalog (ETKA).

• The tire pressure sensor can be reused.

- For safety reason, replace the tire pressure monitoring sensor and clean the rim after using tire sealant.

- Let air out of tire by removing nickel-plated valve insert.

- Remove the tires.

- When changing a tire, replace the valve insert.

- Do not clean the sensors with steam blasting or strong compressed air.

- When reusing used tire pressure sensors, inspect connection between sensor and metal valve visually for damage.

Replace damaged sensors.


• When installing the new sealing washer and the new sealing ring, counterhold them so that the valve body cannot slip through.

• If the connection breaks, then replace the tire pressure monitoring sensor.

- Install tires.

- Install new nickel-plated valve insert.

- Fill tires.

- Balance the tire.

Dismounting Tire






Roll or press the tire off.

When using pressure paddles, first separate tires from side opposite of valve.

• Do not use pressure paddles in hatched area - a -.

- Position mounting head near valve so that so that tire iron can be put on approximately 30° - b - next to tire valve.

- Then remove tire in valve area first.

Mounting Tire






• Do not use pressure paddles in valve area.

- Position tire pressure sensor approximately 180° opposite the mounting head.

- Press tire in bed approximately 90° in front of mounting head - arrow -.

- Mount tire.