Battery Monitoring Control Module

Battery Monitoring Control Module

Removing






- Switch off ignition and remove ignition key.

- Remove the luggage compartment floor - 3 -.

- Remove the dirt tray, if applicable.

- Remove the bass box - 2 - if applicable.

- Fold back the carpet - 1 - over the flap.

- Unlock the retaining tabs - arrows - and open the cover - 1 -.






- Remove the vehicle tools, if applicable.

- Open the cover - 2 - over the battery negative "-" terminal.






- Loosen the nut several turns and remove the battery ground (GND) cable - 3 - from the battery terminal.

- Disconnect the electrical connector - 4 -.

- Remove nut - 1 - and ground cable - 6 - with the battery monitoring control module (J367) - 5 -.

Installing

• Tightening specification. Refer to => [ Battery Overview ] Battery Overview.

Install in reverse order of removal, observing the following:

- Connect battery Battery, Disconnecting and Connecting.

- Install the bass box, if applicable.