Operation CHARM: Car repair manuals for everyone.

ACC Setting Device VAS 6190, Converting for Adjustment Procedure






ACC Setting Device VAS 6190, Converting for Adjustment Procedure

Special tools, testers and auxiliary items required

ACC Adjustment Device (VAS 6190)

Before performing the calibration procedure, check location of the vertical slots on the (VAS 6190). The (VAS 6190) may need to be adapted before performing the calibration.

The (VAS 6190) must be adapted before adjustment procedure. If this is done during the adjustment procedure, the pre-calibration on the (VAS 6190) must be repeated.

- For the adjustment procedure, the vertical slits in mounts - 1 - through - 4 - must be inserted so that laser beam is approximately centered vertically when it contacts the sensor lens.






- The original nut at the top of the horizontal slits must be replaced with a standard nut - 3 -.






The original nut at the top of the horizontal slits must be replaced with a standard nut so that the mirror can be slide far enough to the center.

- The mirror at the center - 1 - must be removed and installed again all the way to the left - arrow - near the vertical slits - 2 -.






- Then the mirror - 1 - must be slide on horizontal slits as far as stop on vertical slits - 2 -.