Hydraulic Oil Cooler, Vehicles With Dynamic Steering

Hydraulic Oil Cooler, Vehicles with Dynamic Steering

Special tools, testers and auxiliary items required

• Hose clamps up to 25 mm diameter (3094)

• Hose clamp pliers (V.A.G 1275)

• Shop Crane Drip Tray (VAS 6208)

Removing

- Remove the front lock carrier cover. Refer to Removal and Installation.

- Clamp off the hydraulic lines - 5 - and - 6 - with the (3094).






- Remove the clamping sleeves - 3 - and - 4 -.






- Disconnect the hydraulic lines - 5 - and - 6 - from the hydraulic oil cooler.

- Release the retaining tabs - 3 -, tilt the hydraulic oil cooler - 1 - forward slightly and remove it from the mounts - 2 - on the A/C condenser.






Installing

Install in reverse order of removal. Pay attention to the following:

• The connections must free of oil and grease, clean if necessary.

- The markings - 2 - on the hose line must point upward in the 12 o'clock position.







• When attaching the hose lines - 1 -, counterhold on the pipe lines - 4 -.

- Top off hydraulic oil.

- Clean any oiled places.

- Bleed the steering. Refer to => [ Power Steering, Bleeding after Replacing ] Power Steering, Bleeding after Replacing.

- Check power steering fluid level. Refer to => [ Power Steering, Checking Fluid Level ] Power Steering, Checking Fluid Level.

- Check all open line connections for leaks. Refer to => [ Steering System, Checking for Leaks ] Steering System, Checking For Leaks.

- Install the front lock carrier cover. Refer to Removal and Installation.

Clamp Installation Position






- Close the clamp completely using (V.A.G 1275).

Do not exceed dimension - A - by 1 mm; if necessary tighten the clamp with (V.A.G 1275).

• Secure all hose connections with hose clamps appropriate to the model. Allocation, refer to the Electronic Parts Catalog (ETKA).