Rear Bumper Cover

Rear Bumper Cover

Removing





- Disconnect the electrical connector - 1 - on the parking aid control module, if applicable.

- Free up the electrical wiring harness on the control module bracket - arrow - by disconnect the cable tie - 2 -.

- Press the grommet - 3 - outward.

- Remove the nuts - 3 - from the threaded pins on the cover - 1 -.





- Remove the screws - 1 - on the upper cover and at the bottom of the spoiler.





- Remove the bolts - 1 - on the lower bumper cover section.





- Unclip the left and right cover on the rear lid end piece. Refer to => [ (Item 10) Clips ] Rear Bumper Cover Assembly Overview

- Unclip the left and right cover from the guides.

- Remove the cover to the rear from the vehicle.

- When installing, the side catches on the guide piece - 2 - must engage completely into the bumper cover - 1 -





- Connect the electrical connector on the parking aid control module if applicable..

- Install the taillamps..