Operation CHARM: Car repair manuals for everyone.
Home >> Audi >> 2012 >> Q5 Quattro (8RB) V6-3.2L (CALB) >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Power Standard Front Seat, With or Without Memory >> Memory Seat/Steering Column Adjustment Control Module

Memory Seat/Steering Column Adjustment Control Module







Memory Seat/Steering Column Adjustment Control Module

Special tools, testers and auxiliary items required

• Removal Wedge (3409)

• Seat Repair Stand (VAS6136)

Removing


• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnic components (for example, disconnecting the connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

- Remove the front seat. Refer to => [ Power Standard Front Seat ] Power Standard Front Seat.

- Attach the front seat to the (VAS 6136). Refer to => [ Front Seat, Installing on Seat Repair Stand ] Overhaul.

- Disconnect the connectors - 2 through 5 - on the control module - 1 -.






- Unclip the tabs - arrows - using the (3409).

- Carefully tilt the control module - 1 - in the - direction of arrow B - out of the retainers - 2 -.






- Slide the control module in the - direction of arrow A -.

- Disengage the tabs - arrow - from the control module bracket.

- Remove the control module from the bracket.

Installation


• Follow all safety precautions when working on pyrotechnic components.

• Before handling pyrotechnic components (for example, connecting electrical connector), the person handling them must discharge static electricity. For example, by briefly touching the door striker pin.

Installation is reverse of removal, but note the following:

• Make sure the memory seat adjustment control module engages audibly in the retainer.

• Make sure the connectors are installed all the way in and are secure.


Connect the battery with the ignition switched on. Pyrotechnic components could deploy after connecting the battery if they were not repaired correctly. Individuals must not be inside the vehicle when connecting the battery.

- Connect the battery ground cable with the ignition turned on.

• If the airbag indicator lamp (K75) indicates a fault after installation, the DTC memory must be checked, deleted and checked again using the Vehicle diagnostic tester.

pro multis · About Operation CHARM