Trim, Sill Side

Trim, Sill Side

• Removal and installation can be done with seat installed.

Removing






- Raise the front seat all the way up.

- Remove the screw - 5 - and the remove the trim spreader clip - 4 -.

- Disengage the rear trim - 1 - on the seat - arrow A -.

- Open the clip - 2 - on the trim and disengage the bracket - 3 -, then carefully remove the seat forward.

- Disconnect the retainer - arrow - between the storage compartment - 2 - and the sill side trim - 1 -.






- Disengage the trim from the bracket and remove it forward.

- Disconnect the connector - 4 - on the lumbar support adjustment switch - 3 -.






- Disconnect the connectors - 1 and 5 - and on the seat adjustment control head - 2 -.

- Remove sill side trim.

Installation

Installation is reverse of removal, but note the following:

• Make sure the connectors are installed all the way in and are secure.

• Make sure the sill side trim is engaged correctly on retaining bracket and lock clip is closed.

• Make sure the wires are as close as possible close to the connectors - 1, 4 and 5 -.