Headrest

Headrest

Special tools, testers and auxiliary items required

• Adjustment Gauge (3371)

• There are two different versions for the headrest release on the outside rear headrests. These two different versions are what makes removing the headrests different. Check to make sure which version you are working in and proceed accordingly.

• The Adjustment gauge (3371) is required for version 2 only.

• The center headrest is always removed according to Version 1.

Version 1, Removing






- Press the button - 3 - for the headrest height adjustment - 2 - in - direction of arrow - and pull it - 1 - upward and out of the backrest - 2 -.

Version 2, Removing






- Press the button - 3 - for the head restraint height adjustment - 2 - in - direction of arrow - and pull the head restraint - 1 - out of the backrest - 2 - until it stops.








• The release - 3 - is always positioned in the direction of travel. and on the right headrest guides on the right-hand side.

- Insert the (3371) that has a 2 mm thickness between the headrest guide - 1 - and the cover - 2 -; then press the release - 3 - in - direction of arrow -. At the same time, pull the headrests - 4 - upward and out of the rear seat backrest.

Installing Both Versions

- Slide the headrest into the backrest as far as the bottom position.

- Check if the headrest locks correctly.

• It must not be possible to pull the headrest back out of the backrest.