Garage Door Opener Control Module (J530)

Garage Door Opener Control Module (J530)

Removing







Danger of unintended engine ignition.

Turn off the ignition and remove the ignition key from the vehicle interior for all work performed on the high voltage vehicle.

- Switch off ignition and remove ignition key.

- To remove the expanding clips - arrows -, carefully push the pin - 1 - to dimension - x - until it audibly engages into the expanding clip - arrow A -.

• Dimension - x - = 5 mm.

- Remove the unlocked expanding clip - 2 - and the pin.

- Lift the cover - 3 - on the lock carrier and engage it on the radiator grille.

- Disconnect the electrical connector - 1 -.






- Release the retaining clip - arrow - and remove the garage door opener control module (J530) - 2 - from the retaining frame.

Installing

Install in reverse order of removal, observing the following:

- Install the lock carrier cover on the radiator grille. Refer to Removal and Installation.