Fuel Tank With Attachments Overview
Fuel Tank with Attachments Overview
1 Nut
• 20 Nm
2 Fuel Line
• To engine
• Do not kink
• Attached to the fuel tank
• To disconnect, press release button on connection piece
3 Fuel Tank
• Removing and installing, refer to => [ Fuel Tank with Attachments ] Fuel Tank With Attachments
4 Bolt
• 20 Nm
• For securing the fuel filler tube and the ground connection - 9 -
5 Overflow Hose
6 Rubber Gasket
7 Cover
• Turn until it engages audibly
• Attached to fuel filler door insert with fastening device
8 Ground Connection
• For discharging electrostatic charge
• Installed position, refer to => [ Fuel Filler Tube Ground Connection ]
• Make sure the connector is securely seated and wiring is secured by the fuel filler tube bolt - 5 -
• After installing, check the electrical connection of the metal ring on the fuel filler neck to a bare area of the chassis an using Ohm meter - Specified value: approximately 0 ohms.
9 Bolt
• 20 Nm
10 Vent Line
• To the EVAP canister
• Do not kink
• To disconnect, press release button on connection piece
• Attached to the fuel tank
11 Securing Strap
• Rear
12 Bolt
• 20 Nm
13 Heat Shield for Fuel Tank
14 Bolt
• 2 Nm
15 Exhaust System Mounts
16 Bolt
17 Rubber Grommet
18 Securing Strap
• Front
19 Spacer Sleeve
20 Bolt
• 20 Nm
Locking Flange Cover - Tightening Specifications
- Tighten the bolts - arrows - for the cover - 1 - to 1.5 Nm.
Bracket - Tightening Specification
- Tighten the bracket nuts - 1, 3 and 4 - to 20 Nm.
Fuel Filler Tube Ground Connection
- Make sure the filler tube threaded connections - 1 and 2 - are free of corrosion so the ground connection to the body is not affected.
- Route the ground connection - 3 - as shown in illustration
- Engage the ground connection contact - 7 - into the opening in fuel tank and then install the spacer bushing - 6 -.
- Make sure the ground connector - 4 - fits securely on the fuel filler tube metal ring - 5 -.
Danger due to electrostatic charge.
• After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.
• Specified value: approximately 0 ohms.