Dynamic Steering Assembly Overview

Dynamic Steering Assembly Overview

The following illustration shows the component locations - 2 - and - 3 - on a LHD vehicle.






1 Power Steering Pump

• With an electric control valve depending on the engine.

• The control valve is installed in gasoline engines only.

• The power steering pump and control valve are one component and are replaced together.

• Installation location in vehicles with 4 and 6-cylinder engines: on the front left of the engine (belt drive).

2 Actuator

• Must not be loosened or removed from the steering column.

• The actuator and steering column are one component and are replaced together.

• The system must be calibrated if the actuator is replaced. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.

• Removing and installing, refer to => [ Steering Column ] Steering Column.

3 Active Steering Control Module (J792)

• The system must be calibrated if the active steering control module is replaced. Refer to => [ Dynamic Steering Basic Setting ] Dynamic Steering Basic Setting.

• Removing and installing, refer to => [ Level Control System Control Module ] Level Control System Control Module.